Grasshopper

algorithmic modeling for Rhino

different rotation with the same slider??????

hi, i have a little problem. I must rotate two point and i must control these with the same number slider. But the first point must rotate of 90° and in the same time the second must rotate only of 45°.

i know how rotate but i can't divide the increase of the number slider for the second point.

help meeeeeeeee..:)

Views: 291

Replies to This Discussion

Permalink Reply by you_shall_not_crash on November 28, 2013 at 3:30pm

I'm not sure if I understand your problem right but I'd say put a Division on the path of the slider before it connects to your second point

Permalink Reply by Lorenzo Polli on November 28, 2013 at 3:38pm

ahahahha yessss..i was stupidd..thank you very very muchhh..:)

Permalink Reply by you_shall_not_crash on November 30, 2013 at 7:54pm

No worries dude ;)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service