Grasshopper

algorithmic modeling for Rhino

Diamond surface

i Guys,

I have a series of curves which i have lofted together using the arc function.

To create the dimond panels from the loft i have to perform a debrep surface (i think) which splits my surface into 4. This causes an issue straight away as my numbers in the U and V direction are multiplied. I am also faced with triangles where there should be diamond

I think this is the source of my issues in the script.

At a later point i mirror points of the diamonds and the triangles are being left as open gaps at the next debrep.

If anyone could help me with this i believe that the rest of the definition should work perfectly. I am sure it is an easy fix but i just cant seem to figure it out.

Views: 2022

Attachments:

Replies to This Discussion

Permalink Reply by rhys lupton on December 15, 2015 at 11:13am

just for clarity, the definition above refers to a piece of the work not included. The bit i am struggling with starts here 

Permalink Reply by Hyungsoo Kim on December 15, 2015 at 12:02pm

Hi.

Try to use rebuilded curves for your lofting instead of using arcs.

As you can see, It can make "Untrimmed surface". Othewise, using arcs will generate "Open Brep".  

Attachments:
Permalink Reply by rhys lupton on December 15, 2015 at 12:34pm

Thank you so much, that is just incredible. Just so i might learn, where did you come to the numbers that you input to the rebuild curves?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

Switch to the Mobile Optimized View

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service