Grasshopper

algorithmic modeling for Rhino

Diagrid on compex surface

Hello!

 

Does anyone know how could i create a diagrid around a complex shape where the angle of the diagrid can be controlled and as well the diagrid would be baked as connected lines (and not segments)  as the image bellow?

(obviously when i say complex shape i dont mean the sphere that is on the attached image :P)

 

so if you applied on a simple shape like this:

 

 

The diagrid would follow its shape as the grid that its on the above surface, but the angle of the diagrid could change as well....

 

 

thanx guys!!!

Views: 3143

Replies to This Discussion

Permalink Reply by fernando molas garcia on May 12, 2012 at 3:39pm
Permalink Reply by richie hawtin on May 12, 2012 at 5:20pm

thanx! will check it..

Permalink Reply by biboarchitect on May 12, 2012 at 9:44pm

If you just need lines you can use weaverbird component (Sierpinsky Triangles subdivision), to achieve the faces for all, I had to use other Sub-D softwares to do so.

Also you can use Evolute tools!

Haven't tried lunchbox although, but I think it is using surface UVs, which is not the case here.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service