Grasshopper

algorithmic modeling for Rhino

delay on connecting new components

This problem was already posted here yesterday, but to explain more clearly:

If you pump up a file by internalising data to a couple MB, you experience a slow down whenever you try to connect new components.

This even occurs if all data is stored in a single disabled component with no preview and you connect to an extra empty component next to it.

So is there just a natural border for the size of a GH?

Why is there a delay, if there is no effect on the stored data anyhow?

Views: 1133

Replies to This Discussion

Permalink Reply by David Rutten on April 17, 2013 at 9:02am

I think it's because of autosave. Provided the connector event setting is enabled in the Preferences, every new wire will cause an autosave update. The larger the file, the longer an autosave will take.

Can you try disabling autosave to see if the performance goes back to normal?

--

David Rutten

david@mcneel.com

Poprad, Slovakia

Permalink Reply by phillip on April 17, 2013 at 9:44am

Pfff...

Thank you!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service