deforming points grid

Hello there,

I'm fairly new to Grasshopper - I just started 2 months ago.

I need to be able to change and control a points grid. Right now, I'm having a homogeneous points grid. I need to be able to adjust the grid so that I have a larger grid in the middle while having denser grid on the edge of the base surface.

The grid should not exceed the base srf.

In the end I need to have a points grid again.

The final goal is the create a hexagonal structure. If anyone knows an easier way to do this than I did, please feel free to help me out there, too ;)

Thank you so much.

Best regards,

Stefan

Attachments:

100325_hexagonal_grid.ghx, 230 KB
103025_hexagonal_grid.3dm, 2.6 MB

Replies to This Discussion

Permalink Reply by Flow on May 26, 2010 at 6:03am

Hey Stefan,

do you have any improvements on your problems? I am failing at the same problem right now!
Regards

Permalink Reply by Stefan Bader on May 26, 2010 at 10:28am

Hey there,

No, I wasn't able to adjust the grid in Grasshopper. But I was able to change the grid in Rhino with inserting control points.

That had the same effect.

Best,
Stefan

RSS