deform triangle grid

Replies to This Discussion

Permalink Reply by nickudi on January 9, 2012 at 8:11am

Hi sebastian,

 

did you work with kangaroo yet? i am new to kangaroo, so i cant give you detailed information for your problem, but you could create forces, which are pulling your grid in directions you want...

and i bet there are possibilities, to let these forces act "randomly" on several points of your grid...

 

may the force be with you!

Permalink Reply by RWNB on January 9, 2012 at 9:02am

maybe this is helpful?

i think that you just have to triangulate the surface, anstead of subdividing!

http://wooj.files.wordpress.com/2009/09/grasshopper-workshop-at-cor...

Permalink Reply by RWNB on January 9, 2012 at 9:21am

because of kangaroo..

maybe you are able to bind the tuts. above with daniel def. (nervsys.ghx, nervsys.3dm)

http://www.grasshopper3d.com/forum/topics/how-to-change-a-flat-hexa...

the link works, if you write at the end hexagonal.

Permalink Reply by Sebastian L. on January 9, 2012 at 11:09am

Thx for your replies!!

The approaches sounds good! I will give them a try the next days, ...

I will post the progress soon! Thx again!