algorithmic modeling for Rhino
Hello dear grasshopper community,
As attached in my geometry file, i would like to know if its possible to deform overlapping boxes. Ideally, with the corner boxes having a 45degree angle.
Ive been incapable of dividing a brep as a whole, and the sweep function behave strangely when i input all my curves at once. I procedeed by sweeping 4 sides, and when i use the Suface Box component, they all overlap. (as shown above)
Is there a way to avoid this?
Here is an exagerated illustration, where i moved the edges after baking the Sbox, so the corners dont overlap.
Thank you very much for your help
Daniel
Tags:
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by