Grasshopper

algorithmic modeling for Rhino

Defining rhino blocks in GRasshopper, and bake it while conserving the layers

Hi Everyone,

I'm working in Rhino and grasshopper for few years, but i can't find a way to set rhino blocks into grasshopper, in order to modify them, and then bake them again into rhino while conserving the same layers. For instance, for architecture, how to reproduce a system like "Dynamic blocks" for Autocad, with Grasshopper ?

Does anyone has something to suggest to me ?

Thanks a ton in advance ))

Kostya

Views: 2688

Replies to This Discussion

Permalink Reply by Laurent DELRIEU on March 11, 2017 at 3:21pm

I don't know very well that but there is Elefront plugin (used for Zaha Hadid Morpheus Hotel in Macau)

http://www.food4rhino.com/app/elefront

http://www.grasshopper3d.com/group/elefront

A good discussion on Discourse 

https://discourse.mcneel.com

https://discourse.mcneel.com/t/gh-elefront-removing-existing-block-...

And there is also Panda Plugin

http://www.food4rhino.com/app/panda

http://www.grasshopper3d.com/group/panda

Permalink Reply by José Jero on March 11, 2017 at 3:33pm

Ok i will check all this, thank you !

Permalink Reply by Andrew Heumann on March 18, 2017 at 11:31am

Human also supports the re-definition of blocks - and you can specify attributes (layer and other information) just like you would if baking. 

Permalink Reply by José Jero on August 17, 2017 at 9:19am

Thank you so much Andrew, sorry for the late reply, I only see your message now.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service