Decontructed half-sphere

I think that picture says it all but still i will explain. I am trying to make a sphere whose radius will fit into a section curve (similar to the one in the second pass) that than will be cut into half. The third pass of this is something like possibility to cage edit the half-sphere that remains. I can do it with rhino only, but the problem is that i need it to be parametric because i want to do the ecotect simultaneous irradiation study because its is going to be a facade.

Now, is this possible or should i continue cage-editing ?

thanks

Replies to This Discussion

Permalink Reply by Gogash on December 4, 2013 at 7:19am

something like this but with the curve boundary and the possibility to add more control points in the middle

Attachments:

decons. sphere.3dm, 430 KB
Sfera slittata.gh, 5 KB

Permalink Reply by Gogash on December 5, 2013 at 1:12pm

Ok so i arrived to the point i have a half sphere and i can parametrically morph it. In case you were wondering this is how i wanted it. I now have to extrude (or offset) the surface for a sandwich wall, and after that i have to make divide it into panels. The only problem is that it won't extrude :( can someone help me?!

since it's supposed to be the sandwich wall i have to have doule

Attachments: