Grasshopper

algorithmic modeling for Rhino

DAYSIM Shading Control Modes, Idealized Automated Control

Hi

I am simulating blinds that behave according to the amount of radiation on the surface of the window and I need to input radiation thresholds to simulate its behavior in reality, now I wonder should I do it with Idealized Automated Control?

is there any possibility to set thresholds for outdoor sensor according to the amount of radiation it gets on vertical surface? 

Views: 214

Replies are closed for this discussion.

Replies to This Discussion

Permalink Reply by Mostapha Sadeghipour Roudsari on September 11, 2016 at 10:02am

As you have have probably figured it out already you can use a sensor to control blinds in Daysim. To represent a vertical surface sensor you just need to make sure the normal is a horizontal.

Permalink Reply by Ata Chokhachian on September 28, 2016 at 2:30am

Thanks a lot dear Mostapha

Do I need to run glare analysis in order to set outdoor sensors?

Is there any sample file that I can have a look?

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service