Grasshopper

algorithmic modeling for Rhino

Data Tree and Loft Issues

The loft data trees I am working with are not working properly...


Step 1: input surface and offset 

Step 2: take offset surface and scale inwards to create custom upper loft curve

Step 3: loft base curve and upper custom curve


Problem: the loft to the basic offset curve is working but for some reason the custom curve loft is not lofting properly.

 

It outputs null from the loft component... any ideas?


Thanks!


attached code and example file below



Views: 746

Attachments:

Replies to This Discussion

Permalink Reply by Zach Hines on May 21, 2010 at 12:46pm
Well I actually answered my own question and thought I would post the solution...

After checking out the post by Ra -Need help with lofting curves, I was able to use the Param Viewer, simplify, and graft components to get the data paths formatted correctly.

Thanks Danny Boyes for the help!

4.jpg
Attachments:

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service