Grasshopper

algorithmic modeling for Rhino

Data Record

Hello Everyone,

Im willing to know if it is possible to store diameter value affected to list of line per index, for example for line 0 i will affect 180 for the 5 legs , for line 2 i will affect 150 for the five legs etc...

I tried to use data recorder but it does not give the results I expected , may be Something wrong or missing from my side

do you think that this is possible in GH ?

Any help would be greatly appreciated, Thanks!

Attached files :

Views: 622

Attachments:

Replies to This Discussion

Permalink Reply by Jonathan Story on August 15, 2017 at 1:59pm

I'm not sure if I understand fully, but if you want to set a different radius for each set of pipes you could do it like this:

The same principle can be used if you wanted to control the vertical legs diameter too.

Good luck,

Jonny

Permalink Reply by said on August 17, 2017 at 4:47am

Thanks Jonathan for your help

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service