Cut Parts of a Spline?

Replies to This Discussion

Permalink Reply by Danny Boyes on October 28, 2013 at 2:40pm

You would need to specify the locations of the blue lines and then use the Shatter Component afterwards you could sort on a Z and and keep the lowest centre.

Permalink Reply by J Frölich on October 28, 2013 at 2:54pm

Thanks a lot! 

Sorry for that stupid question, but what kind of a slider is that you used there (im really new to grasshopper ;) )

Thanks!

Permalink Reply by Danny Boyes on October 28, 2013 at 3:03pm

That is the [Point on Curve] component

Permalink Reply by J Frölich on October 28, 2013 at 3:46pm

Thanks a lot!!!

It worked!