curvy to flat Srf

Replies to This Discussion

Permalink Reply by Michael Pryor on September 20, 2011 at 4:23pm

Do you mean to loft? Post an example.

Permalink Reply by Sebastian D Kriegsmann on September 21, 2011 at 6:22am

inbetween these two i want to have the surfaces which morph from one into the other…

 

Permalink Reply by RWNB on September 21, 2011 at 6:40am

can you post your surfaces!

Permalink Reply by Pieter Segeren on September 21, 2011 at 6:44am

Just use Non Uniform Scale in Z direction only.

Permalink Reply by RWNB on September 21, 2011 at 7:59am

hi pieter,

 

i'm sure that you have s solution for this problem!

Permalink Reply by Michael Pryor on September 21, 2011 at 8:34am

This is how I would do it.

Permalink Reply by RWNB on September 21, 2011 at 8:59am

yes, the way is possible!

Permalink Reply by Pieter Segeren on September 21, 2011 at 9:01am

Flatten the SrfGrid P input

Permalink Reply by RWNB on September 21, 2011 at 9:11am

Permalink Reply by Pieter Segeren on September 21, 2011 at 11:24am

Permalink Reply by Michael Pryor on September 21, 2011 at 11:52am

If only all definitions were this simple.

Permalink Reply by RWNB on September 21, 2011 at 2:17pm

du machst es dir einfach. (:

• ‹ Previous
• 1
• 2
• Next ›
• Page