Grasshopper

algorithmic modeling for Rhino

Curve on surface?

Hellooo

I'm not sure what I'm doing wrong but basically I want to interpolate a curve between two points along a surface which is an extruded arc.

here's what happens atm... it creates this weird curve in the rhino abyss

what is want is this... (i've done it in rhino here not ghop :P )

A little help would be greatly appreciated! Thanks in advance :)

Views: 540

Attachments:

Replies to This Discussion

Permalink Reply by Dedackelzucht on December 5, 2012 at 3:12am

This is my version

Best Regards

DeDackel

Attachments:
Permalink Reply by Ash Low on December 5, 2012 at 1:52pm

thank you!

Permalink Reply by Chris Tietjen on December 5, 2012 at 4:49am

Attachments:
Permalink Reply by Ash Low on December 5, 2012 at 1:52pm

thank you!!!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service