Grasshopper

algorithmic modeling for Rhino

Curve Closest Point (Crv CP) error

Hi,

I spent some time to troubleshoot my Grasshopper file working not properly, and I found out that the issue has to do with a "Curve Closet Point" component. The last point fed into the Crv CP component creates "t" values higher than 1, even though all the curves are reparameterized. These point are very close to parameter "1", but I have other points getting right "t" values very close to 1 in my script.

I'm attaching a GH file duplicating this issue seeking for help.

Crv%20CP.gh

Thank you.

Dongyeop

Views: 1241

Replies to This Discussion

Permalink Reply by Dongyeop Lee on August 14, 2017 at 3:50pm

It's not a fail proof solution, but I just adjusted seam on curves to get the script working.

Permalink Reply by Abel_HYH on August 14, 2017 at 7:38pm

higher than 1？I think “1.6488e-9” means "0.0000000016488", close to "0" rather than "1".

Permalink Reply by Dongyeop Lee on August 16, 2017 at 1:48pm

You're right. I was wrong on that...

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service