Curve along Points ? (!SERIES!)

Hi !

I need a little help, because i do not know how to make an "interpolate curve" between points. These points are one of the corner points of a group of rectangles which are separated from each other. I have got 30 rectangle above each other with command "MOVE" and "SERIES". These rectangles are also rotated. So i want to put through each "A" point of the rectangles a curve. Actually my aim is to create a surface between corner points A1,A2,...A30 and corner points B1,B2...B30 of the rotated group of rectangles with help of SERIES. Any ideas ? Thanks for any replies !

Yes, yes i want to make the 101nth boring twisted tower.... :))) :))

Replies to This Discussion

Permalink Reply by Danny Boyes on June 18, 2010 at 10:03am

Hi Miklós, you could do something like this where you're selecting the same control point to interpolate a curve through, If your doing only one tower then the flatten component will suffice, however, if you're intending to do multiple instances then the Path mapper as shown will work better

Danny

Permalink Reply by Miklós Hatvani Deák on June 18, 2010 at 10:14am

Hi Danny !

Thanks i will try !

Permalink Reply by Miklós Hatvani Deák on June 18, 2010 at 10:47am

Hi Danny !

Thank you ! I am bit closer i think. One and the last question ! How do you use Path Mapper ??

Permalink Reply by Miklós Hatvani Deák on June 18, 2010 at 10:56am

Well the path mapper says : "Floating Parameter Path mapper failed to collect data"

Everything seems working fine only the path mapper and the interpolate curve does not (Orange Colour). Why is that ?

RSS