Culling points with different Z values

Replies to This Discussion

Permalink Reply by Joseph Oster on March 31, 2017 at 6:59am

This thread does exactly that:

Set Member Index Example (MIndex):
http://www.grasshopper3d.com/forum/topics/set-member-index-example-...

Permalink Reply by Laurens on March 31, 2017 at 7:31am

fantastic, thank you! Strange it didn't come up when I was searching

Permalink Reply by Joseph Oster on March 31, 2017 at 8:39am

Applied that very same code a few days ago on this forum, to a different set of points, same result - vertical lines:

http://www.grasshopper3d.com/forum/topics/tolerance-issue?commentId...

Permalink Reply by Laurens on March 31, 2017 at 10:52am

I've run into a small problem with trying to apply it for two separate lists, is there an obvious solution to this? I can't think why it would work for a single flattened list but not this. 

Attachments:

• Cull_dupPointsZ_00.gh, 21 KB

Permalink Reply by Hyungsoo Kim on March 31, 2017 at 11:01am

Hi.

Check this out. Best.

Attachments:

• Cull_dupPointsZ_00_re.gh, 18 KB