cull patterns

Replies to This Discussion

Permalink Reply by David Rutten on April 5, 2014 at 2:35pm

Hi Nilou,

please post a GH file (with 3DM if necessary) so we can work with the real data.

You don't have to include the entire file, you can just put all your curves into a single Curve parameter and then Internalise it (via the menu). 

--

David Rutten

david@mcneel.com

Permalink Reply by Nilou on April 5, 2014 at 3:10pm

Thanks for your reply, here are the files.

Permalink Reply by David Rutten on April 5, 2014 at 4:07pm

I used a closed test to cull all interior curves, instead of counting the points. That's also possible, but closed/open seemed to make more sense here.

The problem is that after you cull the interior curves, the boundary curves are not in the correct order. I had to sort them along a rectangle to make it work:

--

David Rutten

david@mcneel.com

Attachments:

• persiangeometryforum.gh, 52 KB

Permalink Reply by Nilou on April 5, 2014 at 4:16pm

Many thanks David, it perfectly works for the design :)

Permalink Reply by Paul Goodship on April 7, 2014 at 8:17pm

Some different ways  for similar results. 

Attachments:

• New slice persiangeometryforum.gh, 60 KB
• New slice 2 persiangeometryforum.gh, 55 KB
• New slice 3 persiangeometryforum.gh, 56 KB

Permalink Reply by Nilou on September 3, 2014 at 6:52pm

Thanks Paul, It seems that I haven't noticed this post for some time!