Grasshopper

algorithmic modeling for Rhino

Cull Pattern Problem

Hi Everybody,

I am trying to control a pattern as attached by an x-direction slider and an y-direction

slider to increase / decrease the number of elements.

It works fine for the y direction however not for the x-direction as shown in the attached graphic.

When the x direction slider is set to 4

in x direction five times 3 elements should be visible

which is not the case (see image 3) just five times 2 elements are appearing.

The same problem is happening when the x direction slider is set to 7

only 2 elements are shown in eleven rows.

Please have a look at the attached GH definition and the jpg which explains the problem.

I would be very glad if someone could help me to fix that problem.

Thank you for your support.

Views: 687

Attachments:

Replies to This Discussion

Permalink Reply by peter fotiadis on August 4, 2016 at 3:41am

Like this?

Attachments:
Permalink Reply by peter fotiadis on August 4, 2016 at 4:23am

Added a LOL factor

Attachments:
Permalink Reply by Findie on August 4, 2016 at 7:09am
Peter ,
I dont get ur post.
Permalink Reply by Hyungsoo Kim on August 4, 2016 at 4:11am

Hi.

Try this(Using "unflatten Tree") as well.

Attachments:
Permalink Reply by Findie on August 4, 2016 at 7:06am
Thank you so much Hyungsoo Kim!!!
I recreated it and it works fine.
I will study the shift list component tomorrow. Again thank u for your support.I really appreciate ur help.
Its not the first time that u help me to understand grasshopper better.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service