Grasshopper

algorithmic modeling for Rhino

cull pattern issue

Dear All,

From this set of curves I am trying to cull every other curve, but I don't understand why it doesn't appear to be responding - I see that it appears to be reading ALL curves as one entity - I have tried exploding it, joining it, just about everything I can think of! It can read that there are 110 curves though....... is anyone able to tell me where I'm going wrong? Many thanks in advance!

Views: 243

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on March 19, 2014 at 11:08am

You have a single curve on a path try something like [Shift Paths] or <Flatten> the input to get the curves all on one path

Permalink Reply by Tash Tash on March 19, 2014 at 11:13am

wonderful - thanks so much for your speedy reply!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service