Grasshopper

algorithmic modeling for Rhino

Cull duplicate vertices in a joined mesh

Hi Forum,

Just a quick question. When I join multiple meshes together (instead of drawing it bottom up), I end up with duplicate vertices. Is there a clever way to clean the mesh?

Views: 1608

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on October 20, 2016 at 11:59pm

Hi.

"Join Mesh" is not enough. You should "weld" mesh vertices. Try "Weld Mesh" component after Join mesh.

Permalink Reply by Anders Rod on October 21, 2016 at 1:00am

Thanks! That was excatly what I was looking for.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service