Grasshopper

algorithmic modeling for Rhino

Cull by Curve Length

Hello,

I have a curve parameter with about 1000 curves (each with a different length) and want to be able to isolate some of them by their length. Let's say the shortest is 1 foot and the longest is 5 feet and I want to select all the ones between 2.5 and 3 feet. How do you do that? I'm guessing it's simple but can't seem to figure it out.

Views: 4173

Replies to This Discussion

Permalink Reply by Mateusz Zwierzycki on September 27, 2012 at 8:27pm

Curve length + Inculdes + Cull pattern (these are components names, just search them with a pop up search (double left clikc on canvas))

Permalink Reply by Ignatius Reilly on September 27, 2012 at 8:54pm

Perfect. Thanks.

How can I call out the shortest and longest curve lengths?

Permalink Reply by Michael Pryor on September 27, 2012 at 9:37pm

here

Attachments:
Permalink Reply by Ignatius Reilly on September 28, 2012 at 12:16pm

Thanks a lot.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service