Creating surfaces from voronois

I'm trying to create a network of spaces using voronois like in this project:

http://blog.4ofseven.com/0809m9-course/0809-mc-adaptive-formations-...

I've offset the edges of my voronoi 'cells' and created diagonal edges to link them - and here's where the problem occurs. I'm trying to form a surface from the 4 points (2 from the edges of the original cell, 2 from the edges of the offsetted cell). Been on this for a while and cannot figure it out - possibly because so many voronoi cells complicate the whole thing?

Can anyone help me? Would greatly appreciate it!

Attachments:

VORONOI_1.3dm, 691 KB
VORONOI_1.ghx, 551 KB

Replies to This Discussion

Permalink Reply by Dedackelzucht on July 1, 2011 at 4:25am

Hey,

you do not need to create lines or points for the Srf. Use the original and offset line, thats enough to loft.

Have a llok at the files.

Best Regards

DeDackel

Attachments:

VORONOI_1_DeDackel.3dm, 749 KB
VORONOI_1_DeDackel.ghx, 528 KB

Permalink Reply by Red Hong on July 1, 2011 at 9:26pm

hello!

Thank you for your reply, appreciate it.

However, I'm not trying to extrude/loft the centres of the voronoi cells - I'm trying to loft the in betweens, the 'lines'. If you look at the photos in the link I mentioned, the cells are connected, whereas in the file you sent, the cells are disconnected. Do you know a way around this?

Thanks!

Permalink Reply by Andrew Heumann on July 1, 2011 at 10:04pm