Creating of organic wall

Replies to This Discussion

Permalink Reply by Deepthi on May 19, 2010 at 3:08pm

Hey Dmytro!
Actually I am working on a woven surface for my project as well. I was wondering how to make a proposal for insulation. Could you give me any idea?
Thanks

Permalink Reply by Dmytro Lutsak on May 19, 2010 at 4:32pm

Sorry, but I don't quite understand what you would like to get. Anyway, you have to try use Autodest Ecotect, for analysis your surface.

Your structure is cool, is it possible to see the definition file of it? many thanks in advance

cheers

Permalink Reply by Jerrimo on June 4, 2010 at 5:33am

hi Deepthi
i am working also on a woven structure, but i got stuck to cull out the right points. Could you give me a hint how to do that?
I uploaded an image of a woven structure in the background. In front of the image is the attempt to bring this structure in u/v direction on the surface.
Thanks

Attachments:

• Woven Structure.jpg, 518 KB
• Definition.jpg, 229 KB
• Woven Structure.ghx, 1016 KB

Permalink Reply by Jerrimo on June 4, 2010 at 5:46am

for better explanation here an image which kind of structure as a roof i intend to do:

Attachments:

• 3.jpg, 104 KB

Permalink Reply by Dmytro Lutsak on May 19, 2010 at 4:53pm

just to show what I wonder to get...
main idea is rodnom position of both types of lines, vertical and horizontal, I'm sure that somebody already did something like that..

Permalink Reply by Dmytro Lutsak on May 20, 2010 at 6:34pm

Up!

Permalink Reply by Evan C on May 20, 2010 at 7:37pm

I did something similar for a tower design, maybe this will help you.

Let me know if you understand the definition.

Attachments:

• GH Tower 04b.3dm, 49 KB
• GH Tower 04.ghx, 317 KB

Permalink Reply by Dmytro Lutsak on May 20, 2010 at 7:46pm

Many thanks ! that's almost just what I been trying to acheive!
I have a question, how, if it possible to separate vertical and horizontal lines and set different thickness of its??

cheers, D

PS: BTW, I see your code creates only radial ended structure w/o borders, how I remake the code to get ended structure, wall-like...?

Permalink Reply by Evan C on May 20, 2010 at 7:55pm

if you look in my definition, you'll see that the curves above pass through horizontal 'rings' generated from the isocurves of the original lofted surface.... these would correspond roughly to your fence 'stakes' and you can pipe that geometry with a different thickness...

Permalink Reply by Dmytro Lutsak on May 20, 2010 at 8:15pm

piping is ok, you did a toggle for reset it, but I still can't use it for 2D surface, not the 3D like yours... any suggestions?

Permalink Reply by Tristan B on March 25, 2019 at 1:03am

Hi Evan

like your design just wondering is it possible to create something similar on a semi-sphere so it might look like a birds nest?