Grasshopper

algorithmic modeling for Rhino

Creating a surface from spot heights

Hello all,

I was wondering if there was a way to take a load of points from a Rhino model and have surfaces drawn between them as shown below (which I would then use Drape to create a smooth topographical model)?

I have thousands of points so it would take ages in Rhino to do this with the surface from 3 points command. Is there a way to do this on Grasshopper? Surface from points hasn't worked as they're not evenly spaced.

Thanks!

Laurens 

Views: 821

Replies to This Discussion

Permalink Reply by Laurens on February 24, 2017 at 9:30am

I have a hunch that closest points might be involved somewhere but they keep overlapping

Permalink Reply by Laurens on February 24, 2017 at 10:04am

Sorted it! Delauney mesh then Bake -> MeshToNURB (rhino) -> explode -> drape

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service