Creating a surface from a set of points

Hi, I have a set of 15 point varying in all x,y,z directions. I am trying to create a surface that connects them all together, I tried to use the logic of N+1 of the surface from points

http://www.grasshopper3d.com/forum/topics/logic-for-surface-from-po...

but I keep getting the U value error.....any thoughts???

Any help is appreciated.

Replies to This Discussion

Permalink Reply by djordje on November 24, 2012 at 12:26am

Can you post the .3dm file with those points, please?
Thank you.

Permalink Reply by Dalia Hafiz on November 24, 2012 at 12:43am

First thanks for the quick response, I was able to play with it and not getting the error but I am getting flat surfaces since my grid only varies 3 times in the U direction... I am attaching the GH definition, but the points are extracted from a DIVA daylighting, so it may not open... I am inserting a print screen of the points values and saves them in a panel as well....Thanks in Advance!

Attachments:

try_1.gh, 9 KB
Untitled-1 copy.jpg, 472 KB

Permalink Reply by djordje on November 24, 2012 at 12:51am

Add a new "point" parameter before plugging the wire to yellow Panel.

Like this:

Then right click on that new "point" parameter and choose "Internalise data".
Save the .gh and attach it again.

Permalink Reply by Dalia Hafiz on November 24, 2012 at 1:07am

done...please find the .gh attached... I apologize for the mistake

Attachments:

try_2.gh, 9 KB

Permalink Reply by djordje on November 24, 2012 at 1:27am

I am getting flat surface like you do.
And the cause for that is not because of "Surface from points" component.
Cause lies somewhere behind in definition.

Attachments: