Grasshopper

algorithmic modeling for Rhino

Creating a closed curve from control points

Hi guys,

I'm back to Grasshopper after a while.. sorry if this is a simple question 

I'm trying to create a closed curve, using control points from 3 divided curves. however, I keep getting this kinky corner, and I'd like it to be nicely filleted as the others (so that the point acts as a control point).. Any idea on how to do that?

Thanks!

T 

Views: 2371

Replies to This Discussion

Permalink Reply by Matt Gaydon on August 6, 2015 at 4:17pm

Hi Tali,

Firstly Don't weave in the first point in again at the end, then click on the P input of the Nurbs Curve Components and Click TRUE to make the curve Periodic, That should solve the kink issue.

Hope that helps

Matt

Permalink Reply by Tali on August 7, 2015 at 2:26am

Thanks Matt! ;)

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service