create pattern

Replies to This Discussion

Permalink Reply by Armin Seltz on January 18, 2016 at 3:22am

You need to internalise the data on the data inputs in your GH file (preferred) or attach the rhino file as well. Also describing the problem or what you have tried helps ;)

Permalink Reply by deniz ada on January 18, 2016 at 3:51am

they can be attached the rhino, does it possible that rhino curve are not suitable for pattern?

Attachments:

• pattern2.3dm, 31 KB
• pattern2.JPG, 31 KB

Permalink Reply by Armin Seltz on January 18, 2016 at 4:17am

Hm, it wasn't quite showing correctly when I opened your file (the boxes were empty), but I have just set them again and tweaked your grasshopper file slightly.

There is no need to flatten the output of the rectangular grid. In fact it will give you more possibilities, like flipping the matrix (so it goes horizontally and not vertically). Also its easier to know what is going where. As a rule of thumb only graft and flatten if you absolutely need to!

Also to be able to set multiple geometries for each cell, you can just group things together.

Is this what you are after:

Attachments:

• pattern_working.gh, 18 KB