algorithmic modeling for Rhino
Hello,
I am quite new to Grasshopper so please forgive me if I ask a very basic question. I am trying to create a mesh from the below curve network. The curve network has been made with the "ggtrussfromcurves" command from the Geogymp plugin. It looks as if the only thing I need to do is fill each triangle with a mesh, but I just can't figure out how to do it.
I have also tried create the same mesh from a polar array of points in the vertex locations, but I couldn't get that to work either.
The goal is to make a lightweight mesh that can be imported into the Kangaroo folding module so I can try out some circular folding patterns.
I hope somebody can help me out here :-)
Tags:
Hi Hyungsoo Kim,
Thanks so much for thinking along! The mesh works like a charm! Unfortunately there is something about the way the mesh is constructed that affects the way the Kangaroo folding module works.
In fold model 05 I had the folding behaviour working on a 2D sheet of paper (push the boolean toggle on the Kangaroo panel to see)
In fold model 09 (I connected your mesh to the Origami panel) I notice the folding starts only in the top center of the mesh... is that because the mesh is constructed from the top middle downwards? I think I need to find a way to change the way the mesh is formed so the triangles are made one vertical rol at a time. Is that possible do you think?
thanks again,
michel
Welcome to
Grasshopper
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson. Powered by