Create list with overlapping end points

Replies to This Discussion

Permalink Reply by AB on January 29, 2016 at 12:45am

Here is one way to do that...

it uses the Consecutive Domain component

You could of course make your domains "manually" that with the Series component and by getting the last item in the series and using that for the starting point for another series. It would do the same thing as the Consecutive Domain component... it would just be a little more tedious.

Attachments:

• ghForum_OverlappingEndPts.gh, 12 KB

Permalink Reply by Lorenzo Mirante on January 29, 2016 at 3:37am

Thank you AB !
I didn't know about the existence of this tool, consecutive domain, it's very helpful. In fact I was tryng to do it manually but it was very messy and I couldn't obtain a correct output...
Thanks again!

Permalink Reply by Hyungsoo Kim on January 29, 2016 at 1:01am

Plus, you can also use couple of series & listItem.

Attachments:

• OverlappingSelection.gh, 12 KB

Permalink Reply by Lorenzo Mirante on January 29, 2016 at 3:39am

Hyungsoo
thank you very much,
I like this version too!
I will try them both and for sure they will be helpful.
It is exactly what I had to do!

Permalink Reply by Joseph Oster on January 29, 2016 at 9:10am

This same question was asked just twelve days ago!  Are you guys in the same class?

Tree branches with overlapping indices

http://www.grasshopper3d.com/forum/topics/tree-branches-with-overla...