Grasshopper

algorithmic modeling for Rhino

Create hole into brep

Hi all, 

I am trying to create a hole in the cylinder (see picture), I have tried the set difference, the solid difference but they only worked when the brep that you are trying to subtract coincides the original brep. In my case it doesn't. How would I go about this issue?

Thank you for your help

Views: 1702

Attachments:

Replies to This Discussion

Permalink Reply by ng5 Alex on January 2, 2016 at 10:36am

Hello Godjenka,

take a look at this post. deals with what you are asking.

best

alex

Permalink Reply by Godjenka on January 2, 2016 at 1:12pm

Ooh, I had not seen this one, thx a lot for referring me. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service