Create Grid from curves

Hi all,

I've been trying to generate a grid from collection of curves using the Divide Distance with Reference component. First, I set all the referenced points by using the ending points of the curves, then connect them into the P input of the component.

However, once it generated a grid, the ending points at the lower floors were gone. I could not understand why those ending points were kept on upper levels while lost near the bottom. I would really appreciate it if you guys can give me some comments about this problem. Thank you so much!

Replies to This Discussion

Permalink Reply by Hien Nguyen on February 29, 2016 at 11:55am

Here are some of the view captures

Permalink Reply by Rajaa Issa on February 29, 2016 at 6:54pm

Can you share the GH file?

Permalink Reply by Anthony Mull on February 29, 2016 at 9:43pm

It looks like your divide distance is longer than the segments at the end of your lines and is causing a few points to be scrambled, but yes please post a definition of the problem if it is yet to be resolved.

Permalink Reply by Hien Nguyen on March 1, 2016 at 9:50pm

Hi Anthony,

You are right that a few points are scrambled and its perfectly fine. It's just I have the problem with the starting points disappearing on lower floors (circled in red) while they should show up just like the upper floors

Permalink Reply by Hien Nguyen on March 1, 2016 at 9:46pm

Hi Rajaa, Anthony,

I'm sorry for the late reply. I have attached the GH file here

Attachments: