algorithmic modeling for Rhino
Could not morph multiple curves onto surface using SrfMorph component
I could do it with a single curve but not with more than 1. Attached is the file.
Thanking in advance.
Views: 397
- Attachments:
-
-
150930_CurveMorphing.gh, 13 KB
-
Replies to This Discussion
-
Permalink Reply by Riccardo Majewski on
-
On the SrfMorph component, graft the geometry "G" input (right-click).
-
About
Welcome to
Grasshopper
Translate
Search
Photos
Videos
-
Field Contour
Added by Parametric House 0 Comments 0 Likes
-
Voronoi Facade
Added by Parametric House 0 Comments 0 Likes
-
Weave Mesh
Added by Parametric House 0 Comments 0 Likes
-
Pathway Frames
Added by Parametric House 0 Comments 0 Likes
© 2024 Created by Scott Davidson.
Powered by
