Grasshopper

algorithmic modeling for Rhino

Could not morph more than 1 curve at a time using the SrfMorph command

I had no problem with 1 curve, but could not do it when assigned more than 1.

Attached is the file. Thanking in advance.

Regards Fong

Views: 370

Attachments:

Replies to This Discussion

Permalink Reply by Hyungsoo Kim on September 30, 2015 at 7:16am

Hi.

Try "graft" or "group" to your curves.

Permalink Reply by Fong Weng Kong on September 30, 2015 at 7:36am

TQ

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2025   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service