Grasshopper

algorithmic modeling for Rhino

is posible make 3d cylinders or another geometry by lines? i kno this is posible in 3dstudio ma but i cant find the way of making it on rhino

Views: 5171

Replies to This Discussion

It is a bit unclear what your actually are searhing for. But you should check out the components LOFT or/and EXTRUDE. 

- Michael

i kno hot to use loft and extrude, what i i am searching is like....supose u have a plan ith lots of lines and u want to make this lines reanderizable...

Okay.

Well to render curves in Rhino: Render -> Render Properties -> ON/OFF Render Curves and isocurves

But In a project last summer I where in same situation as you, and ended up making the curves into pipes.

I wanted them to be visualized as "curves" so I created a definition that fixed the radius of the pipes, so that the pipes fitted as "curves" for the camera (rendering).  This was by using Grasshopper. In that way I got "fatter" curves, actually rendered pipes. 

- Michael

lots lots lots of thanks man

i am trying to do it but i just do not get it.....

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service