converting curve to poliline

i try to convert a set of curves into polilines with equally spaced segments (at least as similar as possible, while dividing each curve into equal segments):
i succeed in dividing the curves and outputting the points (1), but then when trying to shatter the curves usimg these points i end up with too many curve segments (2, for better visibility i generated the endpoints on these curves and moved them along x).

i also tried to flatten the shatter and the divide input(s), but without any effect.
thanks in advance for any help.
roberto

Attachments:

tst.3dm, 21 KB
04_gh_ng.ghx, 86 KB

Replies to This Discussion

Permalink Reply by Damien Alomar on October 30, 2009 at 10:05am

I'm not really sure what shattering the curve really does for you. If you've divided the line in a way that works, why not use those points to make the polyline directly.

Permalink Reply by roberto gagliano on October 30, 2009 at 4:58pm

thanks!
i didnt know about the poliline component ...
my workflow was more like imitating a rhino workflow:
create points, splitting the curve (shatter) and then rebuilding the segments.

RSS