Grasshopper

algorithmic modeling for Rhino

contructing a "folding line"

Hallo,

I am trying to copy a circle (same radius) to provide a line with the same length l, but different angles (because of the two input references line (it is a kind of folding pattern)

The point ist, I have to do this like 75 times (when i am doing this , my question is can someone please show me or, give me a suggestion how to produce the "loop" or series of these circles to construct these lines with the same length =radius).

Or is there any other way around? Any help and suggestions appreciate.

Views: 477

Attachments:

Replies to This Discussion

Permalink Reply by Pieter Segeren on November 7, 2014 at 11:42am

Hi gabor,
here is a way using Hoopsnake looping. You could also use Anemone instead.
(The arc angle domain is -pi/2 To Pi/2. b.t.w.)

Attachments:
Permalink Reply by Pieter Segeren on November 7, 2014 at 2:55pm

The Anemone loop is way easier on the eyes, and also a bit easier to operate... :

Attachments:
Permalink Reply by gabor on November 8, 2014 at 3:59am

Hi Pieter, thank you very much!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service