Grasshopper

algorithmic modeling for Rhino

CONTROL POINTS COMPONENT

I use this component to exract control points of a surface..

I am trying to move some of these points to deform the surface but no luck.

Should I assume that this comp just gives these point as a copy with no control over the geometry ?

How can I deform a surface from its control points in GH

Thanks a lot Pantelis

Views: 1049

Replies to This Discussion

Permalink Reply by djordje on March 19, 2013 at 3:03am

Hi Pantelis,

Yes, you are right - once control points are extracted they need to be "imported" again so to say, in order to control the shape of the model. You can do this by interpolating the curves from those points, and then lofting those curves. Or directly making the surface from those points. Check these two methods in the attached files.

Attachments:
Permalink Reply by pantelis apostolou on March 19, 2013 at 7:51am

THANX A LOT !!!!!!!!

very craetive , thanx again

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service