Contours C# components

Giulio,

Is there a version of your contours components that works in Rhino 5 / Grasshopper 9.x?

Think your site says only supported up to Grasshopper 8.2 but wanted to ask. Very handy tools.

Matt

Replies to This Discussion

Permalink Reply by Giulio Piacentino on September 16, 2013 at 2:21am

Hi Matt,

I haven't looked too deep into updating these scripts because now there are 4 different Grasshopper components that work on contouring.

Is there any special thing that you would rather see in Grasshopper, or was this for learning purposes?

Thanks,

Giulio

Giulio Piacentino
for Robert McNeel & Associates
giulio@mcneel.com

Permalink Reply by Matthew Gilbride on September 16, 2013 at 7:30pm

Well, used this a while back and then put grasshopper down for quite a while. So now re-familiarizing myself. I see the contour components under curves. Tried those but have yet to get those working. Will dig around a bit more for the components you mentioned.

Have been using a series of curves projected onto my breps but definitions based on that get bogged down pretty quickly. Looking for something more efficient.

RSS