Grasshopper

algorithmic modeling for Rhino

Constructing cone on a curve

Hi, 

I am new to grasshopper so only have a basic understanding of things. 

I want to create a cone that follows the line I created. Essentially, the base of the cone is the start point of the line and the tip SHOULD be the end of the line (similar to how a pipe is generated around a curve).  

I cannot figure out how to orient/construct the cone in the direction of the line I've created. 

The first image is the part of my script related to the cone. 

The second shows the lines (the direction i want the cones to go) and the existing cones. 

Views: 2304

Attachments:

Replies to This Discussion

Permalink Reply by Kalin Ngo on February 26, 2017 at 4:19pm

Hi there!

Perhaps the BOX MORPH component might suit your task here. This will allow the bases of your cones to connect fully on your surface. See image:

If you don't want to use BOX MORPH, maybe using the ORIENT component will help. However, the base circles won't be projected onto your surface. See image:

I hope this helps.

Permalink Reply by Hyungsoo Kim on February 26, 2017 at 4:20pm

Check this as well.

Attachments:
Permalink Reply by Alexia H on February 27, 2017 at 10:18am

Thanks so much! Exactly what I needed. 

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service