Constrained Inflatables

Replies to This Discussion

Permalink Reply by Jon Mirtschin on October 1, 2013 at 10:25pm

Hi Jano,

My inflating routine works akin to structural analysis, you can constrain the mesh at various locations from the start.  It won't act like a physical constraint (ie when the mesh exceeds past this point, stop it here).  You might have more luck with kangaroo if this is a requirement.  You can start by forming faces with edges on your curves and then meshing those faces and inflating.

Cheers,

Jon

Permalink Reply by Jano on October 2, 2013 at 6:05am

Thanks Jon!

I will give it a try.