Grasshopper

algorithmic modeling for Rhino

connecting the dots

ok
i think i have a simple problem here. Basically i am trying to connect some points with lines (this is basic) however I would like to have the lines offset but still be connected to the same points they were drawn from and have them bed away from the original line. I would also like to have the points act as attractor points that can control the amplitude of the offset.....that might have sounded strange so i have attached a pdf with a drawing trying to explain what i am getting at

Views: 748

Attachments:

Replies to This Discussion

Permalink Reply by Omid MK on November 15, 2009 at 8:12pm
hi Anna,
here is what you could do; as long as you know where your points are, you could use "arc 3pt" component just like in the file i've uploaded here.

hope it hepls
Attachments:
Permalink Reply by u on November 15, 2009 at 8:58pm
hey thanks omid!!
I'll work on it!!

see you tomorrow

anna

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service