Grasshopper

algorithmic modeling for Rhino

Conic Curve Tangent at Start and End

Hello,

Is there a way to create conic curves specifying 'tangent at start and end' like the rhino command in gh?

I have been using Blend Curve and Tangent Curve to varying degrees of success.

I am trying to get the tightest radius as possible without creating a non-tangential 'bump' as shown in the example.

Any help would be much appreciated.

Views: 906

Replies to This Discussion

Permalink Reply by Pieter Segeren on September 19, 2016 at 4:38am

Hi Angela, I think you meant this:

Attachments:
Permalink Reply by Matt Gaydon on September 19, 2016 at 4:45am

Hi Angela, 

Seems Pieter, beat me to posting but here's my answer that also works on curves. 

Attached the 3dm to show the process, (Checked against the Conic Command)

EDIT: Currently not letting me upload files, getting errors from Ning, will try later.

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service