Close curves

Replies to This Discussion

Permalink Reply by Dedackelzucht on September 6, 2011 at 2:47am

Hey

ther are many problems in this. You get quiet close to it with the approximate3D component. The problems are: Even and odd number of pairs in one row. Distance of start to start and end to end Points varies. I would trie to figure this problem out earlier in your process. Trie to kepp your paths grafted. You get this line with a kind of offset of a baseline. this offset in one and the other dircstion( as i guess) should be your pathstructure. difficult to explain.

Sorry I do not have a solution for this problem here.

 

best Regards

 

DeDackel

Permalink Reply by Danny Boyes on September 6, 2011 at 3:31am

Are you stuck with the curves in Rhino or can you generate them from scratch in Grasshopper? If so this is how I would approach this.

Attachments:

• ClosedCurves.gh, 6 KB

Permalink Reply by Joshua Feldman on September 8, 2011 at 7:45am

Thanks Danny that's really helpful. 

 

I think I have managed to get what I am looking for.

 

Josh