Close box when using project?

Replies to This Discussion

Permalink Reply by Hannes Löschke on March 17, 2012 at 3:41am

Cap only works fro planar openings.

Trim the surface, you projected on with th eprojected curve and move the trimmed surfaceto the top of your extrusion.

Joint the trimmed surfaces and the extrusion with brepJoin.

Permalink Reply by Katrine Andreasen on March 17, 2012 at 3:21pm

thank you:)

Permalink Reply by Katrine Andreasen on March 18, 2012 at 3:57am

When I trimm my surface, is this the easiest way to do it?

And I'm not sure how to use the script component? It says that no code is applied?

 

Permalink Reply by Hannes Löschke on March 18, 2012 at 5:20am

I can't see, what your VB component does. But you don't need it.

There's a SplitSurface component, that does that Rhino's split command does. Then it's a matter of selecting the right one with the  list item.