Grasshopper

algorithmic modeling for Rhino

Hi all. I think it's a very simple question, but I can't get the solution.
 I've got a facade made by various cells. Each cell has different size and orientation.
I designed all the cell's boxes starting from each baseline and mooving the boxes on each level.
Then i designed a single cell with two windows and walls between them.
I just want to apply the geometry of the single cell to the boxes of all the cells. 
I tried using the box morph component but there should be something wrong because it doesn't work. 
The best result I get is a repetition of my cell's module always with the same orientation of the original one.
Can anybody give me an help, please? 
Thank you very much.

Views: 1475

Replies to This Discussion

could you post an image or your definition?

that could be useful to understand your problem

best

m

Mario, thank you for reply

theese are the cell's boxes:

this is the single cell module

and this is what i get when i apply the boxmorphing component:

attached you can find the definition, to run it just set some lines (better if planar ) to the geometry parameter you find in the upper right side of the canvas.

thank you  again

av


 

Attachments:

You need to supply Twisted "BOXES" not BREPs that are box like.

Attachments:

Danny too fast for me!

best

m

The hard part was getting the correct order of corners :S

Thank you guys!
Today I was too busy with other stuff to reply. I just opened your definition,Danny,
but I saw just the cells without the windows.. ( could it be because of my GH is an older version?)
Tomorrow I will try to understand better what's the problem and will reply.
But, thank you again!
Best
Av

What version are you using? It could be I used the new Tree Explode.

Danny, actually when I opened your def I didn't see that component and I had 6 error messages.
the vertex-to-box component had no connections and now, watching your picture, i understand why.
Tomorrow when I come back to office I'll try to install the newest version and test your def again. Then I will tell you.
Thanks

Hi Danny,

i'm sorry but i can't reply till now.

i downloaded the latest version and your def works perfectly, but - most important - thanks to your help i think i've understood what was wrong in mine.

i'm trying to go on with the def so i think i will post some other stupid question.. so stay online ready to reply :)

thanks also to mario.

bye

RSS

About

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service