circle into squares and hight changes

Replies to This Discussion

Permalink Reply by Pieter Segeren on March 6, 2011 at 2:41pm

Hi Eva, I'd like to try to help you out, so I looked at your definition. I think you need to rephrase your question because I don't understand what you mean...

Permalink Reply by Eva on March 6, 2011 at 3:06pm

Hi Pieter,

Thank you very much for help. So, now I have circles, I need squares instead, this I managed to fix I put polygon instead of circle. And now I want to change the hight of the volumes. For example, if I have an attractor and it could influence on the the hight changes. Or if it is possible without attractor would be great.

Permalink Reply by Pieter Segeren on March 6, 2011 at 5:10pm

an attractor point you mean?
If yes: use distance component, to measure the distance(s) from attractor point to the points of your grid, then use these to control the extrusion height.
If no: how would you like to control the heights?

Permalink Reply by Chris Tietjen on March 6, 2011 at 6:31pm

Hi Eva,

I hope this helps a little bit.  It could be modified to include the use of an attractor point to control height.

Chris

Attachments:

• skyscaper.ghx, 158 KB