Choose between two curves

Hi, i should choose through a number slider one curve of these to extrude, someone could help me?

Replies to This Discussion

Permalink Reply by Michael Pryor on May 31, 2012 at 10:13am

list item

Permalink Reply by overcraft on May 31, 2012 at 10:47am

well, but with a list item and then dispatch, the curves will be extrused togheter

Permalink Reply by Michael Pryor on May 31, 2012 at 11:21am

I don't get what you want the result to be?

Permalink Reply by overcraft on May 31, 2012 at 11:28am

no, becouse only one of the first curves should be extrused through the numb.slider, i know this is a ridiculous thing but i can't solve it!! too time in front of this project!

Permalink Reply by overcraft on May 31, 2012 at 11:32am

with the two results of dispatch for A, for example shuold be extrused the curve below, for B the curve above

Permalink Reply by Michael Pryor on May 31, 2012 at 11:41am

im sorry i dont understand your description, can you sketch it.

Permalink Reply by overcraft on May 31, 2012 at 11:53am

Permalink Reply by Michael Pryor on May 31, 2012 at 12:03pm

so just extrude one of your curves, no need to use list item or dispatch, it seems you are joining both together into list item.

Permalink Reply by Sameer Kumar on May 31, 2012 at 12:14pm

I think you need to flatten your 'L' input in the List Item component... In the image above, both the curves have an index number '0'. Once you flatten them and bring them to the same tree level, they will be 0 and 1, and your slider will correctly pick them.

Permalink Reply by Michael Pryor on May 31, 2012 at 12:28pm

yes, but in his case, the list item makes no sense, because the two curves are already separate, so just use the one you want. based on the screenshot he would be grouping the 2 curves to immediately separate them again.

Permalink Reply by overcraft on May 31, 2012 at 12:46pm

it was for this if the list item and dispatch don't working, becouse there are two source object, and only one at time shold be extrused

Permalink Reply by Sameer Kumar on May 31, 2012 at 12:49pm

From the screenshot, I am not sure what the Dispatch component does for you. If all you are trying to do is creating a switch for which curve goes through, then either one of the List Item or Dispatch would do it and you wont need both.