Grasshopper

algorithmic modeling for Rhino

Check if points are inside or outside

Hi Guys,
I have a surface with subsurfaces and I have a closed line on the surface. I want to make a check, which midpoints are inside this curve and which ones are outside. I didn´t find it in the forum but I´m sure there must be quite a simple solution. Any suggestions?
Thanks

Views: 4011

Attachments:

Replies to This Discussion

Permalink Reply by Danny Boyes on October 5, 2009 at 8:04am
Hi Simon,

One way might be to use the Inside component in the Analysis Section of the Surface Tab. You would have to create a BRep from the curve to enclose the points.

Best regards,
Danny

Permalink Reply by Simon Vorhammer on October 5, 2009 at 8:16am
Danny, this is exactly what I was searching for. Thanks a lot!

RSS

About

Scott Davidson created this Ning Network.

Translate

Search

Photos

  • Add Photos
  • View All

Videos

  • Add Videos
  • View All

© 2024   Created by Scott Davidson.   Powered by

Badges  |  Report an Issue  |  Terms of Service